Hpe Smart Array S100i Sr Gen10 Sw Raid Driver For Windows Server 2022 | DIRECT REPORT |

is a software-based (chiplevel) RAID rather than a hardware-based controller, Windows Server 2022 will not recognize your configured RAID arrays during a clean installation without the proper storage driver.

Use the filter drop-down menu to select Microsoft Windows Server 2022 .

Make sure you update both the driver (in Windows) and the System ROM/BIOS (for S100i functionality) using the Service Pack for ProLiant (SPP). is a software-based (chiplevel) RAID rather than a

Select the newly revealed drive allocation and proceed with the installation normally. 6. Post-Installation Best Practices

(Note: The slot number might differ; replace "0b" as needed based on your system output). Select the newly revealed drive allocation and proceed

Insert both the Windows Server 2022 installation media and the driver USB drive into the server. Boot the server and launch the Windows Setup wizard.

Navigate to System Configuration > Embedded Storage > Smart Array S100i SR Gen10 . Insert both the Windows Server 2022 installation media

Modify the value from SATA AHCI Support to . Save the configuration and reboot the server. 2. Build the Logical Array Re-enter the F9 System Utilities menu during boot.

: A blank USB drive (FAT32 formatted) to load the extracted driver files.

Efficient software RAID management.

Successful installation requires careful preparation. Follow this checklist to avoid common pitfalls.