Current input for x/5A or x/1A transformers; voltage input up to 440V AC.
Programmable from 0.80 inductive to 0.90 capacitive.
Measure the line voltage with a calibrated multimeter. Adjust the internal overvoltage protection limit if utility spikes are normal.
Proper physical installation ensures operator safety and precise measurements. Always isolate power supplies before mounting. Mounting the Unit
If you have a specific question about the installation, wiring diagrams, or parameter settings for the BR5016, I can provide that technical information directly. --- Epcos Power Factor Controller Br 5016 Manual Pdf
The unit should be installed in a switchboard cutout. Ensure the ambient temperature does not exceed depending on the specific model environment.
Epcos Power Factor Controller BR 5016 (also referred to under the
If you are currently setting up the unit, would you like help with the step-by-step programming menu or a specific wiring diagram for your capacitor bank? Power Factor Controller - TDK Electronics
Range from 30V to 525V AC (L-L or L-N).
The EPCOS BR 5016 is an intelligent, microprocessor-controlled device. Its primary function is to continuously monitor an electrical network's power factor and maintain it at a desired level by automatically switching capacitor banks on or off. This ensures optimal energy efficiency, reduces losses in transformers and distribution systems, and helps avoid penalties from utility providers for a low power factor.
Features Class 2 measurement accuracy for grid parameters.
The Epcos Power Factor Controller BR 5016 Go to product viewer dialog for this item.
The BR 5016 (part of the BR 5000 series) is built for versatility in power quality management. Current input for x/5A or x/1A transformers; voltage
RS485 communication port (Modbus RTU protocol) for integration into Energy Management Systems (EMS). 2. Mounting and Wiring Installation
Fits a standard panel cutout of 138 x 138 mm (device size 144 x 144 x 125 mm). Connection:
Ensure the monthly average matches your utility's billing requirements to avoid reactive energy surcharges.
If you are currently setting up a specific configuration, please let me know: What is your ? Adjust the internal overvoltage protection limit if utility
The Epcos BR 5016 (now produced under the TDK brand) is a digital power factor controller. Its primary job is to monitor the reactive power in an electrical network and switch capacitor steps in or out to maintain a target power factor (usually close to 1.0).
Includes automatic step switching based on internal temperature monitoring (0–70°C) and protection against over/under voltage and frequency. TDK Electronics Installation and Operation Notes Initialization: Supports automatic initialization for system setup. Switching Times: