Egs002 Proteus Library -

Complete Guide to Integrating the EGS002 SPWM Driver Board in Proteus

Since there is no "official" Labcenter-provided model, you can obtain the library through these methods: EGS002 Sinusoid Inverter Driver Board User Manual

The is a specialized module for single-phase pure sine wave inverters, typically featuring the EG8010 ASIC and IR2110S driver chips . To use it in Proteus, you must typically import a third-party library, as it is not a standard component in older versions of the software. Where to Find the EGS002 Library egs002 proteus library

The EGS002 driver board EGS002 Symbol, Footprint & 3D Model by EGmicro - SnapMagic (url) is the core component of many modern inverters. It features: A dedicated, high-performance SPWM generator IC. IR2110S: A high-frequency MOSFET driver chip.

Over-current protection pin that shuts down the system if a threshold is crossed. Complete Guide to Integrating the EGS002 SPWM Driver

If you already have a schematic symbol file ( .LIB ) you downloaded:

If you are trying to to see if it works: Do not use the EGS002 block. Replace it with an Arduino Uno in the simulation running an SPWM code. This is the standard way to simulate this type of inverter in Proteus because the physics of the EG8010 chip logic is not publicly available for modeling. It features: A dedicated, high-performance SPWM generator IC

Connect the four SPWM drive pins from the EGS002 library model directly to the gates of your four H-Bridge MOSFETs. Ensure the high-side and low-side pairs match perfectly to avoid simulated short circuits.