Jbl N7000 Schematic [repack]

The core design of the N7000 is a 2-way frequency dividing network. It features a crossover point at 7,000 Hz, which is exceptionally high compared to modern standards. This high transition point was intentional; it allowed the woofer to handle the majority of the vocal range while the 075 tweeter added "brilliance" and "shimmer" to the top end. The network is an 8-ohm design, ensuring compatibility with the standard impedance of JBL professional series drivers.

"The N7000 dividing network provides a means of adding the 075 to existing high-quality two-way loudspeaker systems to obtain added brilliance in the high frequencies." — JBL Literature 5. Differences: N7000 vs. N8000 While similar, the N7000 and N8000 are not identical. 7,000 Hz crossover, ideal for 075/077. N8000: 8,000 Hz crossover.

I can provide tailored wiring schematics and assembly advice based on your exact setup. Share public link

The JBL N7000 is a legendary frequency dividing network (crossover) engineered during the golden era of high-fidelity audio. Designed to manage the precise transition of audio signals between low-frequency woofers and high-frequency compression drivers, it remains a highly sought-after component for vintage audio restorers and DIY audiophiles.

The N7000 is designed for easy integration. According to the original JBL instruction manual, the network connects directly to the high-frequency terminals of the main dividing network, such as the N400, N500, N1200, or LX5/LX7. jbl n7000 schematic

Here is a simplified diagram representing the signal path through the JBL N7000:

Uses a capacitor in series with the signal to protect the tweeter from high currents below 7 kHz.

A wire-wound potentiometer or multi-tap switch allows users to adjust the high-frequency output level.

Based on traditional JBL designs, the N7000 schematic includes: The core design of the N7000 is a

The N7000 was primarily designed to accompany JBL's high-efficiency components, frequently paired with legendary drivers like the JBL 075 bullet tweeter or the LE85 compression driver. 7,000 Hz (7 kHz)

Generally, these are paper-in-oil or early film types. Over decades, these tend to degrade, changing their value and negatively affecting the crossover point.

Original schematics show a value close to 0.6 mH (part numbers include 10421 or 13219P). Capacitor: Standard value is 1.5 µF (JBL part #10460).

Usually features a 12 dB per octave slope to ensure clean driver integration. The network is an 8-ohm design, ensuring compatibility

The N7000 was primarily engineered to extend the high-frequency performance of existing two-way systems. By introducing a crossover point at

Disassemble the cast-aluminum or bakelite housing carefully.

If you are looking to build a clone or repair an existing JBL N7000 network, component selection is critical to achieving the signature vintage sound without introducing modern distortion. Standard Value (16-Ohm System) Standard Value (8-Ohm System) Recommended Type Paper-in-Oil (PIO) or High-Quality Metallized Polypropylene Inductor ( L1cap L sub 1 ) Air-Core, Heavy Gauge Copper Wire (14-16 AWG) Attenuator 16-Ohm L-Pad 8-Ohm L-Pad Wire-wound Variable Resistor / Rheostat Common Restoration and Recapping Steps

Restorers often use the original schematic to create a new, modern circuit board, replacing the 40-50 year-old components with modern equivalents to ensure accurate crossover performance. Similarities with the N8000

Because original factory units were often potted (filled with a hard pitch or epoxy compound to reduce resonance and protect components), uncovering the exact circuit diagram historically required careful extraction.