Omron G8b-201-01 Page

Cruisers utilizing VT and VF designations (e.g., VT700, VT1100, and the high-performance V65 VF1100S Sabre).

Relays are mechanical switches exposed to continuous engine vibration and moisture. Over time, internal contact degradation or coil burnout will trigger distinct failure modes: 1. Solid Burn (No Blinking)

The Omron G8B-201-01 power relay module is suitable for use in a wide range of applications, including:

If you need the or a replacement suggestion , let me know. omron g8b-201-01

The is a miniature printed circuit board (PCB) power relay. It is widely used in automotive and industrial applications for switching moderate loads with a low control signal.

Unlike early thermal flashers that rely on a bi-metallic strip heating up and cooling down to break the circuit, the G8B-201-01 relies on solid-state timing circuitry paired with a physical switching contact. This design provides a highly stable flash rate, irrespective of minor fluctuations in ambient temperature or battery voltage. Omron Corporation

Alternatively, if you prefer not to splice resistors into your factory wiring harness, you will need to replace the G8B-201-01 with a modern, fully digital, load-independent electronic flasher relay. Sourcing and Replacement Options Cruisers utilizing VT and VF designations (e

The relay typically has 5 pins arranged for through-hole PCB mounting.

Based on the features and benefits of the Omron G8B-201-01 relay module, we recommend it for use in:

The is a specialized, highly durable 12-volt electronic flasher relay engineered by Omron Device & Module Solutions. It is widely recognized as an Original Equipment Manufacturer (OEM) component for a broad range of classic and modern Honda Motor Company motorcycles and scooters. Responsible for regulating the steady blinking rhythm of turn signals, this micro-component is vital for on-road compliance and rider safety. Solid Burn (No Blinking) The Omron G8B-201-01 power

Riders seeking a clean, modernized electrical architecture usually prefer an all-electronic, load-independent replacement relay over splice-in resistors. 🔧 Installation and Maintenance Steps

The turn signals do not light up at all when the switch is engaged.

: Rated for operation between -40°C and +80°C . Compatibility & Applications