Icom Ic-f310 Programming Software
Do not touch the cable or power source until the software confirms the write process is 100% complete.
Determine which channels the radio monitors when the Scan button is pressed.
You need an OPC-478 (RS-232) or the more modern OPC-478UC (USB) cable. This connects to the microphone jack on the front of the radio.
If you are using the modern OPC-2344-1 or a USB-to-Serial adapter, you must install the Icom USB driver correctly. Never connect the programming cable to the PC until after the driver software has been installed.
Before writing new data, you should from the radio. Connect via the correct COM port (e.g., COM3). Select "Read" from the menu. The software will download the current codeplug from the radio. Always save this original configuration as a backup (.icf file). Icom Ic-f310 Programming Software
A: You likely wrote an incompatible codeplug (e.g., a 128-channel configuration to a radio with limited memory) or the firmware is mismatched. Re-load the original backup.
The CS-F300 Programming Software is designed specifically to interface with the IC-F310 (VHF) and IC-F410 (UHF) series radios. It allows users to program essential operating parameters from a Windows-based PC.
This guide covers everything you need to know about sourcing, installing, and using the programming software for the Icom IC-F310. 1. Identifying the Correct Software (CSF300 / EX-1762)
A: .icf (Icom Cloning Format) is the standard data file used by Icom's official cloning software. Some third-party software may use .dat files, but the Icom ecosystem primarily relies on .icf . Do not touch the cable or power source
For those running newer operating systems, Icom eventually released the interface. This modern interface uses a USB connection and is designed to replace the older OPC-1122U and OPC-478 systems. The OPC-2344-1 interface is plug-and-play with Windows, automatically installing the necessary drivers when connected to the internet.
: The original software often requires MS-DOS or older versions of Windows (like XP) to run correctly. If you are using a modern PC, you may need a DOS emulator or a dedicated legacy machine. Required Hardware & Cables
Yes, for custom frequencies, scan lists, and professional repeater usage, the software is mandatory. Conclusion
Go to and save this original configuration file in a safe folder. Step D: Editing Frequencies and Settings This connects to the microphone jack on the
Since this is legacy equipment, the software was originally designed for older versions of Windows. If you are using Windows 10 or 11, you may need to run the application in Compatibility Mode . Step-by-Step Programming Guide 1. Connection and Driver Setup
The standard IC-F310 covers a frequency range of , while the IC-F320 covers 146–174 MHz (H-band) . Depending on the firmware and hardware revision, the radio can support up to 32 channels (organized in 16 channels across 2 banks), making it suitable for complex fleet communications.
This radio is particularly noteworthy because its programming method represents a "transitional" technology. The early IC-F310 models rely on (EX-2057), while later models or specific "S" variants (like the IC-F310S) utilize a Windows-based interface known as CS-F300S . Consequently, "Programming the Icom IC-F310" is not a one-size-fits-all process; you must first identify which software your specific radio requires.
These models often require Icom CS-F300S .