Erhardt-leimer Do 3001 Manual -

Adjust the controller gain (sensitivity) to prevent hunting or sluggish response.

Check M12 cabling. Verify the CAN termination resistors are properly positioned in the network. Ambient light interference or heavy machine vibration.

For linear movements or specific actuators, use the Elbody software tool

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

: The system locks tracking strictly onto the right edge sensor. Erhardt-leimer Do 3001 Manual

The DO 3001 relies on digital networking architecture to pass signals instantly between controllers, sensors, and actuators.

Wipe down the glass optical windows using an alcohol-based lens cleaning solution and a microfiber cloth. Avoid abrasive materials that can scratch the protective glass. Diagnostic Troubleshooting Matrix Symptom / Fault Potential Cause Remedial Action Guiding system drifts constantly Material edge outside the measuring range. Readjust mechanical position of sensor bracket. "Sensor Error" on Controller Cable damage or loose M12 connector. Check continuity of wiring harness; re-seat plug. Erratic readings on clear film Covered calibration was not performed correctly. Redo calibration protocol using the exact clear substrate. Intermittent signal loss Heavy dust accumulation over the lenses.

Web flutter, wrinkles, or vertical height fluctuations will cause focus loss and measurement errors. Ambient Light Protection

The DO 3001 operates natively within the Erhardt+Leimer CAN-bus ecosystem, minimizing complex field wiring. Adjust the controller gain (sensitivity) to prevent hunting

Insert the DO 3001 from the front, ensuring the perimeter rubber gasket is flat.

Standard variants offer field-of-view windows optimized for precise edge tracking (commonly around 10 mm to 30 mm depending on lens configuration).

Periodically verify that all communication cables are securely attached to the actuators and controller. Troubleshooting

Only trained personnel should operate or maintain the Erhardt-Leimer equipment. Ambient light interference or heavy machine vibration

The is a sophisticated web guide system (often referred to as a web guiding controller) used in printing, packaging, and converting industries to keep material webs aligned.

Proper installation is crucial for the optimal performance of the web guiding system.

Check the CAN bus cable and power supply to the controller.