Remington Rand 1911a1 Markings Access

Fake Remington Rand markings fall into two categories:

This article provides a deep dive into every rollmark, inspection stamp, serial number range, and subcontractor code found on a Remington Rand M1911A1.

The right side is stamped "M1911A1 U.S. ARMY" below the serial number. 4. Barrel Markings

This final military acceptance stamp features two crossed cannons inside a circular belt. On Remington Rand pistols, this mark is often lightly struck or partially faint. Inspection and Proof Marks remington rand 1911a1 markings

This is the most common slide variation. It correctly identifies Syracuse, New York, as the manufacturing location.

Found on the left side of the frame (near the magazine release button).

The Dulite (early) or Parkerized (late) finish should match perfectly between the slide and frame. Fake Remington Rand markings fall into two categories:

Note: Many Remington Rand 1911A1s were refurbished after the war, so finding a "correct" all-original pistol is rare. Refurbished pistols often have additional stamps from arsenals like Rock Island Arsenal ("RIA").

The address was shortened to "REMINGTON RAND INC. / SYRACUSE, N.Y." in smaller lettering. This is the most common variation. 2. Frame & Inspector Markings

Marked "REMINGTON RAND INC. / SYRACUSE, N.Y. U.S.A." in large letters. These are the rarest and were typically finished in a Du-Lite blue. Inspection and Proof Marks This is the most

Features a significantly smaller, more compact logo, typically found on later parkerized models.

These appear on :

Is the barrel stamped with "HS" or "F" on the lug? (A commercial barrel or blank barrel indicates a replacement).

This is the most common variant. The logo is noticeably smaller, measuring approximately 1 inch in length, with the same two-line Syracuse address. Essential Frame Markings