V2ray Mikrotik ((full)) Here

/interface bridge port add bridge=dockers interface=veth1

Familiarity with IP address management and Mangle rules. Step 1: Enable Container Feature on MikroTik

Create a virtual Ethernet interface and a isolated bridge for the container.

/ip/firewall/mangle/add chain=prerouting src-address=192.168.88.50 action=mark-routing new-routing-mark=v2ray_route passthrough=yes comment="Route specific device through V2Ray" Use code with caution. Troubleshooting Common Issues v2ray mikrotik

This ensures that any packet with the proxy_mark routing mark is forwarded to the container’s IP address (our veth1 interface) for processing.

V2Ray is significantly harder to detect via Deep Packet Inspection (DPI) compared to standard VPNs like L2TP or OpenVPN.

The V2Ray container needs a virtual environment to communicate with RouterOS and the local network. 1. Create a Virtual Ethernet (VETH) Interface Troubleshooting Common Issues This ensures that any packet

Create a bridge or add the IP to your existing setup so the router can talk to the container:%%MAGIT_PARSER_PROTECT%% ip address add address=172.16.10.1/24 interface=bridge Step 2: Configure V2Ray Environment Variables and Files

Then bind container’s proxy port to a local address and redirect traffic as in Method 1.

V2Ray relies on a config.json file. Since you cannot easily edit files inside a running container on MikroTik, you should host this file on the router's disk. Create a folder on your disk (e.g., disk1/v2ray/ ). Upload your config.json to this folder. v2ray mikrotik

Enable the container mode on your MikroTik (this usually requires physical access or a "cold boot" for security). You will need to set up a veth interface and a bridge to allow the container to communicate with your local network. 2. Deploy Xray-Core and Tun2Socks

/ip route add disabled=no distance=1 dst-address=0.0.0.0/0 gateway=172.17.0.2 routing-table=proxy_mark