Mcgs Hmi Touch Calibration

Continue holding for 3 to 5 seconds. The HMI will bypass its standard project boot sequence and launch the built-in system configuration menu or go directly to a white calibration screen.

Inspect internal cooling. Ensure the panel enclosure has adequate ventilation. Replace screen if aging.

: If you enter the startup properties window and do nothing for 30 seconds

: Never use a screwdriver or sharp pen, as this can permanently damage the resistive touch layer. mcgs hmi touch calibration

: Specific areas of the screen fail to register touch.

If you are a programmer designing an interface in , you can build a dedicated "Touch Calibration" button directly into your project's maintenance screen. This makes it incredibly easy for field technicians to recalibrate the screen without rebooting the hardware. Using the MCGS Script Function:

: After calibration, the screen registers no touches at all. Continue holding for 3 to 5 seconds

If your calibration attempts fail, use this engineering checklist to isolate software bugs from permanent hardware degradation. Root Cause Engineering Solution

: Press "Yes" to the confirmation prompt to start the alignment process. Quick Tips for Best Results

: Always calibrate after a screen replacement or significant firmware update. Step-by-Step MCGS HMI Calibration Process Ensure the panel enclosure has adequate ventilation

What or behavior happens when you try to calibrate

This is the fastest method if your screen is so misaligned that you cannot click on-screen menus. Step 1: Power Down the HMI

, the system will automatically launch the touch calibration program. Manual Entry

The screen detects constant pressure somewhere on the glass surface.