Verify the display reads 0 during the clean water flush. If it deviates slightly, use the front panel zero-calibration adjustment.
This is the "brain." It houses the LCD display, keypad, power supply, and the microprocessor. The manual stresses that the central unit is usually located in the Engine Control Room (ECR).
: Keep the sample water flowing smoothly through the measuring cell. Avoid extreme pressure spikes that could damage internal seals. Electrical Connections
Authorized service agents, like Mackay Marine, are trained to perform repairs and calibrations on the OMD-11. Furthermore, the manufacturer is DECKMA HAMBURG GmbH, whose corporate headquarters is located at Kieler Straße 316 in Hamburg, Germany. They can be contacted for technical inquiries or to locate the nearest certified service center. deckma omd11 manual
Understanding its operational framework, calibration procedures, and routine maintenance is critical for preventing environmental pollution and ensuring regulatory compliance. 1. Technical Specifications and Overview
If this lights up, check the sample flow, power supply, and for internal component failure.
Comprehensive Guide to the Deckma OMD-11 Bilge Alarm Monitor Manual Verify the display reads 0 during the clean water flush
Requires mounting on a rigid vertical surface, ideally at eye level.
A proper "story" or operational overview for the Deckma OMD-11 Bilge Alarm Monitor Go to product viewer dialog for this item.
Deckma OMD-11 is an older oil-in-water monitor designed for use with 15 ppm oily water separator systems. While it is no longer in production, it remains fully supported and compliant with IMO Resolution MEPC.60 (33) Technical Specifications 0–30 ppm, with trend indication up to 50 ppm. Meets IMO MEPC.60 (33) standards. Alarm Points: The manual stresses that the central unit is
Do not use a generic manual from the internet unless the revision number matches your hardware (Rev. 4.2 versus Rev. 5.0 have different service menus).
This article serves as a comprehensive overview of the , covering key aspects from installation to troubleshooting. 1. Introduction to the OMD-11 Bilge Alarm Monitor
: Move the brush vertically to remove oil films.
However, the manual does provide a procedure for an operational using a 100-FTU (Formazin Turbidity Units) calibration fluid. The engineer would apply the fluid and follow a specific sequence requiring the display to show "161" upon successful completion. This confirms the instrument is reading within acceptable parameters.